About TopTek Introduction
Related Download
Contact Us
TopTek Advanced ceramics Co.,Ltd.
+86 0574-63210962 Mail:

TopTek was started by material and mechincal engineers. We will definetly improve all aspects based on our professional experiences at material selection, component designing and application guiding.
Developing together with you and helping you reach your targets are always one of our key principles.Our experienced engineer group members are glad to share with you about designing, molding, sintering, fine machining and application depends on your requirements.Do not hesitate to contact Advanced Ceramics Expert for amazing solutions.


Some General Guidelines

1. In general, the less we do to the ceramic part after it is sintered, the less it cost. Here is a list of the processing after sintering in order of cost increasing to ceramic part.

-Sintering

-Grinding

-Lapping

-Polishing


2. The different choice of machining also cause the different cost of ceramic part. Below there is a list of machining operations in order of cost increasing to ceramic part.

3. Avoid sharp internal corner and undercut to save the cost and away from stress riser.

4. Avoid knife edge features, because the brittleness of the ceramics.

5. Provide radius and chamfer on each edge to prevent from chipping whenever possible.
6.Tight tolerance causes expensive cost.

365电玩棋牌游戏 上海11选5走势图开奖 51pk10计划专家在线计划 雷诺好彩1预测分析 股票涨跌是谁输入的 快乐十分几时开奖 福彩排列七玩法 股票电台在线收听 河北快3怎么稳赚钱 山东选五开奖结果一定牛 赛车小游戏